Mod2 Board
Mod2 Boardr -
Features:
- CW
- RTTY
- K1EL Compatible
Antenna Configuration
Select your UHF antenna position:
Cooling Options
Configuration Selection
Which software image would you prefer?
$
This kit consists of a printed circuit board with all SMD parts installed (the builder installs the following supplied parts)
- SA818S radio module
- JST right angle male connector (J2)
- 2 conductor cable with female JST connector and 2 hole binocular ferrite to connect to RPi (The two wires on this cable must be soldered to the appropriate pins on your Raspberry Pi boards USB connector)
- SMA antenna connector
- 40 pin female GPIO connector
Options include:
- Fully assembled and tested (additional $25)
- Fan with right angle pin header ($10)
Not included in the kit:
- Antenna
- Any other parts normally included in our SHARiI PiHat Unistorm kit
Note – We can only supply the assembled and tested board with a vertical SMA connector. For the edge mount connector, it will be supplied uninstalled for you to install.